Simple Operation for monitor PH value (Low or High PH will cause the aquarium make disease)
Durable and Reliable
Ideal For Salt Water and Fresh Water
The controler can power on the CO2(Not included)or calcium reactor(Not included) to control the PH value
Specification
Measurement- 0~14pH
Resolution- 0.01pH
Accuracy- 0.01pH
Power for 220V to 240V 50/60Hz
Include PH Pen , calibration
Operation:
Connect the AC power (230V~50/60Hz).
Connect the PH electrode to PH terminal.
Put the PH electrode into the buffer solution with the standard PH7. Adjust the knob "CAL/PH7" with the plastic screwdriver until the display reads "7.00".
Put the PH electrode int the water after calibration and start to work.
Normally, the best PH for plant aquarium is PH6.8~PH7.2 and for the seawater aquarium is PH8.0~8.4.
Connect the CO2 system(Not included) to the controller and it will lower the PH with the CO2 system.
works fine, good quality for money. could have a more decent probe though
00
CommentLikeDislike
kyoshoy Invitadoon18 Ago 2010, 7:21 AM
Correct price
The hysteresys seems to be a little to big (0,15), bat does its best for the price.
I reccomand it.
00
CommentLikeDislike
Kheng on2 Abr 2010, 7:19 AM
Value for money
Easy to setup and use, but the PH setting is very sentive.
00
CommentLikeDislike
Radu on30 Dic 2009, 12:50 PM
quite ok
It's good because it's cheap, it works quite ok with some minor inconvenients: with a pH set at 6.8 it opens the em valve at 6.85 and closes it to 6.71; probe cable too short. pH probe works ok, no em interferences, properly packed both the original one and the supplementary one I ordered
